Toyota Engine Manuals,
The following instructions are organized so that you work on only one component group at a time. This will help avoid confusion from similar looking parts from different sub-assemblies being on your workbench at the same time. (a) To facilitate reassembly, arrange parts in order. (b) Be careful not to mix up or lose clips or springs. (c) Toyota Engine Manuals, Use carburetor driver set SST. Remove air cleaner support, remove throttle position switch, Remove fuel cut solenoid valve (a) Remove the two clamps. (b) Disconnect the solenoid valve and throttle position switch wire from the clamp. (c) Remove the solenoid valve and gasket. Remove nipple union and gaskets. Remove compensator. Remove the three screws, throttle position switch wire clamp, compensator and gasket. HINT: Remove the compensator only if it is necessary to replace it. Remove suction chamber adjusting pin. Remove suction chamber and piston. Remove pump arm. Remove float bowl : (a) Toyota Engine Manuals, Disconnect the fuel heater wire from the clamp. (b) Remove the five screws, union nipple clamp, throttle valve solenoid, wire clamp, washer, number plate, EGR vacuum modulator bracket and float bowl. (c) Remove the pump damping spring from float bowl…..
Download Now
Manual Carburetor Inspection Procedure Toyota Fuel System
Post a Comment